Since 1998

Tour de France riders’ speeds: the commentators’ con

"Over 90 km/h!", "peaks of 100 km/h on this descent".  Sports commentators and pundits outdo each other putting numbers on the dizzying speeds of our athletes on two wheels.  Cutting-edge measuring technology, accurate motorbike speedos, or tall tales? fabien-haddadi.info dissects these otherworldly speeds for you, and above all, their otherworldly Physics.
Sergio Henao flies to victory, supposedly at over 90 km/h on the descent to Nice, according to the commentators.

Introduction

On the final stage of Paris-Nice 2017, we witnessed Colombian Sergio Henao snatch the overall victory by a mere two seconds ahead of Alberto Contador.  To keep his slim lead, our friend Sergio spun like a madman on the slopes leading him to Nice.  So much so that the France 3 commentators (“citation needed”) announced a speed of over 90 km/h.  I’ve heard that kind of thing forever, in the 35-plus years I’ve followed the TdF now and then.  Is it an achievable speed, when we almost never see it on our own bike computers?

Obviously, on the flat, pro riders’ power is truly impressive, and higher than that of the average amateur.  Into a headwind, in a solo breakaway, these guys can ride for hours at over 45 km/h on average, when we’d struggle to reach 30 km/h.  But downhill, on steep gradients, does their power really help them?

The facts

In the video of this stage, a frame of which is shown below, at the moment of the comment about his speed supposedly exceeding 90 km/h, you can see Henao pedalling at 110 revolutions per minute (rpm).  It’s easy to measure this cadence on screen, over a 10-second interval for example, during a continuous camera shot.  This cadence isn’t exceptional, by the way.  It’s high, sure, but perfectly achievable by an average amateur.

What speed can you hope to reach pedalling at 110 rpm?

We assume the drivetrain is engaged, i.e.  the chain is actually pulling, and the freewheel isn’t taking over.  Otherwise, you’re purely freewheeling, so there’s no point pedalling at 110 rpm.  60 would do, to keep the muscles ticking over beneficially*.

they should instinctively think of performing a sustained effort for a few minutes as quickly as possible, so as to effectively reduce the concentration of lactate accumulated in the working muscles (translated from French).

Let’s take a cadence of 110 revolutions per minute, on a “standard” road bike, i.e.  with a 700 rear wheel, so about 2090 mm +/- 1% circumference; let’s take the extreme unfavourable case: 2100 mm (2.10 m).  Let’s take a 53/11 gear, which seems to be the biggest road gear, time-trial setups aside, found at specialist retailers on high-end road groupsets.  Note that 56 and even 58-tooth chainrings exist, but they’re not normally taken on mountain stages.  So we have 53 teeth at the front and 11 teeth at the back.  Each crank revolution produces 53 divided by 11 rear wheel revolutions, i.e.  about 4.818 revolutions, so a total distance of 4.818 x 2.10 m per crank revolution, i.e.  10.12 m.
10 m is a good approximation to within 1%, given the various margins of error involved.

So at that moment of the stage, he covers:
 110 x 10 m per minute, i.e. 1100 m per minute,
 which is 1100 / 60 = 18.33 m/s (metres per second),
 i.e. 18.33 x 3.6 = 66 km/h

So have we been lied to?

Conclusion: to within 1% (the margin of error from the wheel circumference), 66 km/h announced as 90 km/h? Nah, but maybe he’s riding 54/10, my detractors would say.  Even so! That Goliath gear, hard to find on the market, would only lead to about 75 km/h.  20% error, we’re still a long way from the "over 90 km/h" described by the commentators.

Could the follow motorbike’s speedo be inaccurate?

Yes, of course, and speedos have been completely off for 35 years, even though most are digital nowadays; they’d have at least 20% error in the worst case!

I can’t say under what conditions the motorbike’s empirical measurement is made: is the bike accelerating at the time of the reading? What is the speedo’s margin of error? Unless I take the measurement myself, I can’t answer these questions.  What I do assert is that the speeds announced at that moment are fanciful.

What does it take to exceed 90 km/h?

78 km/h was on a long straight descent at 16%Mathematically, and with the equipment considered in this article, the rpm for 90 km/h comes out at 150.  150 crank revolutions per minute! 36% quicker than our Colombian friend.  At that cadence, you wouldn’t have time to push very hard.  The legs, asked to produce positive driving effort, barely have time to push before the pedal is already at the end of its stroke.  To hope to pedal at that speed without bouncing on the saddle, with each pedal stroke bringing its share of newtons (the SI unit of force) to overcome the friction forces involved, you’d need the spring of a grasshopper, hard to achieve with our human quadriceps.  Our human physiology simply doesn’t allow that kind of spring.  At that rpm, you’d have gone past the "cut-off frequency" of the power/rpm response, much like a motorbike engine, for example.

So can you never reach or exceed 90 km/h?
Yes, of course you can, but it’s rare.  All the physical factors need to line up: strong tailwind, very steep gradient (> 12%), aero position, skinsuit, well-lubricated wheel bearings, tyre pressure > 8 bar, very smooth road surface, in short, the perfect storm.  We’re far from having such gradients, over a long enough straight, every time such an announcement is made in the commentary.  Should I prove that you need a straight to reach such speeds, by the way?

The measuring method matters a lot.  To be reliable, it mustn’t be done by GPS, as the signal can always drop out.  Just look at the instantaneous speed shown by a GPS watch to be convinced.  Valid methods are: Doppler, laser, gates fitted with photoelectric cells, magnetic sensor, or a pressure sensor across the road.

In the image above, my bike computer shows a max speed of around 78 km/h, reached this afternoon, the day I wrote this article, on a mountain ride, on a -16% gradient (near Brisbane, Australia), with a very favourable mass: I weighed 80 kg at the time, on a bike over 8 kg net, with tool kit and bottles.  I was in an aero position and there was virtually no wind.

But these guys put out 500 W and more!

Yes, but when? They put out that kind of power on climbs, or in sprints on the flat; but how do you put out such power when you’re already spinning at a cadence of 110? It’s physically impossible for a human, because the speed at which the legs (the pistons) go down barely keeps up with the linear speed of the pedals going down.  You’re not far from “pedalling in semolina”, as we say in French.  It’s simply impossible to put out 400 or 500 W in those conditions.

When physics gets involved

These almost supersonic speeds have always impressed me, as an average Wednesday-and-Sunday amateur rider.  Indeed, I know that down here on Earth, because of air friction and the bike’s own friction, the heavier a rider is, the more easily they’ll reach high speeds downhill, without much effort.

Try riding at the same speed as your child, for example, and both stop pedalling at the top of a hill you’re about to fly down; you’ll see that very quickly your speed will be higher than your child’s, because, according to the fundamental law of mechanics, F = m.a, we have a = F/m, i.e.  the sum of the friction forces opposing the motion of you + your bike, let’s call these forces F, is divided by the mass of the system you + bike, i.e.  m, so the deceleration a due to friction is much smaller than for a child, since m is smaller in the denominator for them.

Me and my 80 kg

Armed with my demonstration above, which establishes that top speeds can only be reached in practice while freewheeling, by fairly heavy guys, on fairly huge gradients, here’s my point: with my 80 kg, I find it all the easier to reach 80 or even 90 km/h.  But for little mountain marmosets like these guys, with bikes as featherweight as they are, it’s a real challenge.
In fact, I’ve reached just over 90 km/h, but never 100.  It was on the Fleurieu Peninsula, south of Adelaide, South Australia.  On the descent to Rapid Bay, to be precise, in the last, very straight section.  I already had my nose a few centimetres from the front tyre, in a maximum aero position, on a 17% gradient, with a strong tailwind . . .   freewheeling, of course.  This speed was recorded with a magnetic sensor on the wheel.  The wheel circumference had been measured beforehand to the millimetre, under load.

In the video, Henao isn’t freewheeling.  That intrigued me, because as an average amateur rider, I do know that all my speeds of 90 km/h or more recorded on my bike computer were measured with a sensor on the front wheel, freewheeling, and on far steeper gradients, not the kind you usually find in France.  You need to know that the road layout in Australia is such that steep gradients are fairly common.  Indeed, roads go straight over ridges, by the shortest route, instead of following the slopes.  Vehicles’ engine power allows it, and it brings a saving on infrastructure costs.

Conclusion

Don’t be fooled by the commentators’ colourful announcements about descent speeds.  Reaching 90 km/h is exceptional with the riders’ weights and the gradients involved.  Motorbike speedos show the motorbike’s speed, with a certain margin of error yet to be defined.  You need to account for the measuring method, GPS? But also the motorbike’s state: is it accelerating?
Finally, a rider pedalling on equipment like that used in the TdF really has no chance of reaching 90 km/h or more.  To reach such speeds, they shouldn’t try to pedal, but rather refine their aerodynamic profile, and above all freewheel, to benefit from the “perfect storm”.

(0 view)
created Monday 17 April 2017
revised Wednesday 04 November 2026 by
Would you accept our confidentiality policy? It is about cookies and personal data...